How to install glazed ceramic mosaic?

The advantages of glazed ceramic mosaics are rich colors and varied styles, which can show people personalized wall decorations, so they are very popular, and they are also one of the widely used home decoration building materials. But maybe you don't know that because the area of mosaic tiles is very small, its construction requirements are also very high. The following is an introduction to the correct installation steps of glazed ceramic mosaic.

Here is the content list:

• Glue preparation

• Paving accessories

• Paste the mosaic

• Detailed inspection

• Air dry

• Daily care

Glue preparation

Before laying the glazed ceramic mosaic, we must first use tile glue or mosaic glue to clean the wall neatly to make the wall flat. At the same time, we have to lay a good foundation for the glazed ceramic mosaic paving and ensure that the temperature is between 5 degrees and 39 degrees.

Paving accessories

As we all know, cement is the most commonly used for paving glazed ceramic mosaics, but because the density of glazed ceramic mosaics is higher than that of ordinary tiles, and the water absorption rate is higher than that of ordinary tiles, the bonding effect of cement is not very good. At this time, we suggest that it is best to paste the mosaic with a beautiful seam agent, which can also guarantee the firmness of the glazed ceramic mosaic very well. Then, while keeping the wall flat, lay the mosaic tiles.

Paste the mosaic

In the process of pasting glazed ceramic mosaics, we should try to use sassafras, and the squeegee must be full, and at the same time, ensure that the area of the squeegee cannot exceed 2 square meters each time, otherwise, it will cause cleaning troubles.

Detailed inspection

After about 20-25 minutes after all the walls have been paved, after the bonding layer is finally set, and after the jointing is completed, do another check. The floating sand left in the seams can be gently wiped with a clean damp soft brush. The extra mile strips should be smoothed with 1:1 cement mortar, and then wiped clean with a cloth. After these tasks are completed, cleaning is carried out. For cleaning, two buckets are required, one for new detergent and one for clean water. First, soak the cloth in the bucket of detergent, without wringing dry, and then wipe the surface of the glazed ceramic mosaic in a circular motion. Then soak the sponge in the second bucket with clean, and then wipe the surface of the glazed ceramic mosaic with the sponge to wipe away all the residues. After all the cleaning work is completed, wipe gently with a dry cloth at the end.

Air dry

After the glazed ceramic mosaic is finished, it can be properly air-dried. The mosaic tiles that have just been laid should be protected from the sun, and the indoor walls should be properly ventilated until about 24 hours after the handover. It is generally stipulated that the post-maintenance of paving-glazed ceramic mosaics should be no less than one week.

Daily care

Normally, we can use clean water to clean the glazed ceramic mosaic. If we encounter stubborn stains, we can use detergent to clean them, and then we must use a lot of clean water to clean them to avoid leaving residues.

Foshan Connfly Decoration Materials Co., Limited is committed to researching glazed ceramic mosaics. If you are interested in our products, you can contact me. Our website is https://www.connfly-mosaic.com/.